There are a lot of questions on how to multiply all values by some other cell or to move all values to another cell based on some value, but what I want is to take, in the example image below:
All the values that I have selected and divide by 2. I do not want another column, I just want to change all those values in the spread sheet and divide them by 2, the values themselves should change.
I have not found an answer for this any where and I sure it is super simple. For example, in:
base_damage_mod
selected column, 0.03 would become: 0.015.
The only way I know to do this is manually, and that's a lot of work ...
Whats the easiest way to do this?
The easiest way to do this is by writing a macro, like in the following example:
Sub Divide_by_2()
For Each c In Selection:
If c <> "" Then
c.Value = c.Value / 2
End If
Next c
End Sub
In order to launch this, you need to select your cells (no need to copy, or press Ctrl+C), and then launch the macro.
As far as the source code is concerned, this is pretty obvious, except for the c <> ""
part: I have added this in order to avoid the value 0 being filled in in empty cells.
Is there a way to do this without VBA, without macros?
Yes, there is, but it involves you creating a new column, in there type a formula, then copy the values of that formula into again another column and remove the first two columns, in other words: it's quite Messi :-)