I know that broken pipe error is thrown when the socket on the peer side is closed.
But, in my test I have noted that an immediate 'send' call on this side when the peer side is closed doesn't always lead to a broken pipe error.
E.g.:
After closing the socket on peer side (I have tried clean closing by calling close and also abnormal closing by killing the peer), if I try to send 40 bytes, then I don't get a broken pipe, but, if I try to send 40000 bytes then it immediately gives broken pipe error.
What exactly causes broken pipe and can it's behavior be predicted?
It can take time for the network close to be observed - the total time is nominally about 2 minutes (yes, minutes!) after a close before the packets destined for the port are all assumed to be dead. The error condition is detected at some point. With a small write, you are inside the MTU of the system, so the message is queued for sending. With a big write, you are bigger than the MTU and the system spots the problem quicker. If you ignore the SIGPIPE signal, then the functions will return EPIPE error on a broken pipe - at some point when the broken-ness of the connection is detected.