simulationanylogic
Anylogic Parameter Variation Experiment output to Excel
I'm trying to use parameter variation experiment of Anylogic and export the result "loss" of each run to the corresponding position in the Excel table. However, only a few of the results are successfully exported to the table. The related code and result are shown below. enter image description hereenter image description hereenter image description here
I am looking for where it went wrong. Thanks!
Solution
You did not share the code that is writing the results to Excel which might be the reason for the problem. However, another possibility is that you have to turn off allowing parallel evaluations under Advanced.
- Error when trying to read binary file in VHDL
- Simulation results not matching the theoretical answer
- Assigning a heat capacity to the surrounding air in a Heating model?
- Verilator, running simulator gives: Invalid argument
- How to repeatedly insert elements into a sorted list fast
- SystemC-AMS: Initialization for tracing of: v_supercap failed set wave to 0
- How to make looping to be the fastest in R?
- Incomplete Trajectories in R Simmer when using Branches within Do_Parallel
- Indefinite Simulation in Modelica
- A few questions about pymunk's accuracy
- What is considered to be a good value for Nash-Sutcliffe Efficiency (NSE)?
- How to computationally model the output of an idealized sensor given its Modulation Transfer Function?
- Why my double pendulum loses energy? Written in C++
- SUBMIT report and simulate button click?
- Combine two resources and then send to a node in Anylogic
- How to generate multiple simulation paths in survival analysis forecasting?
- How do I get a byte[] of the camera frame in unity?
- How to tune PID controller on non-linear model (here: diving of a body)
- Change the number of resources during simulation in simpy
- Trouble with intallation of OMNET++. After running the mingenv file. I run the make command but I got this error and do not know what it means
- How to Constrain Translational Motion Using Prismatic Joint in Modelica? (Stop after x meters)
- Simulation of a spring loaded pendulum on a spinning disk
- Detect collision and run a function in pymunk
- How to simulate a scenario 1,000 times with sample size varying from 100-200 in R?
- Timing simulation in Vivado giving an error
- Matlab/CUDA: ocean wave simulation
- Specify Mass Matrix in ode45() MATLAB
- How to simulate motion of 4 particles moving towards each other?
- iPhone Simulator - Simulate a slow connection?
- Simulation Time in Concurrent VHDL Procedures