The ARM ARM doesn't actually give much in the proper way of usage on this instruction, but I've found it used elsewhere to know that it takes an address as a hint on where to read the next value.
My question is, given a 256-byte tight copy loop of ldm/stm instructions, say r4-r11 x 8, would it be better to prefetch each cache line before the copy, in between each instruction pair, or not do it at all as the memcpy in question isn't both reading and writing to the same area of memory. Pretty sure my cache line size is 64 bytes, but it may be 32 bytes - awaiting confirmation on that before writing final code here.
From the Cortex-A Series Programmer's Guide, chapter 17.4 (NB: some details might be different for ARM11):
Best performance for memcpy() is achieved using LDM of a whole cache line and then writing these values with an STM of a whole cache line. Alignment of the stores is more important than alignment of the loads. The PLD instruction should be used where possible. There are four PLD slots in the load/store unit. A PLD instruction takes precedence over the automatic pre-fetcher and has no cost in terms of the integer pipeline performance. The exact timing of PLD instructions for best memcpy() can vary slightly between systems, but PLD to an address three cache lines ahead of the currently copying line is a useful starting point.