My question is very basic.I need to know where does all Bluetooth profile such HID, HFP or HSP loaded in Bluetooth stack? Is it in Host layer or in Bluetooth Hardware Chipset such as USB dongle/module or in both Host and Chipset Side?
According to my understanding, we can implement Bluetooth profiles on Host side using packages like BlueZ but at same time Bluetooth chipset which is connected to Host should need some sort of firmware and logic(like CSVD, A-law ) inside its chipset.
A quote found in BlueZ Android package doc: "Wideband Speech support in HFP it is required that BT chip assumes mSBC codec". This means Host layer can implement that Profile only if BT chipset provides the low-level support like mSBC.
My Answer is like this: " We can build any Bluetooth Profile say 'X' on Host layer if BT chipset is equipped with underlining Low-level firmware which support the Profile 'X'".Please agree or disagree with my understanding.
PFA diagram of my understanding Position of profile and its low-level firmware
I need to select a USB Bluetooth dongle compatible to Raspberry Pi and customize the HID and HFP using BlueZ.
Advance Thanks to all Bright minds!
There are multiple ways how Bluetooth functionality is implemented in a system based on how much is implemented in the controller and host.
So lets assume you are asking about the 3rd type. In this case your assumption is correct. Here all profiles are implemented in the host only. But protocols/codec needed to support them will be implemented in the controller(either firmware or hardware block). For example GAP(For BR-EDR) is implemented in the host but encryption and decryption algorithms are implemented in the controller as Firmware or hardware blocks. For A2DP profiles audio codec/decoders will be implemented in the controller. BT chip then transfers this audio data to host with I2S or other protocols. For BLE Security manager profile, encryption/decryption algorithm is implemented in the host itself, But whitelist, auto connection etc, will be implemented in the controller.
My Answer is like this: " We can build any Bluetooth Profile say 'X' on Host layer if BT chipset is equipped with underlining Low-level firmware which supports the Profile 'X'".Please agree or disagree with my understanding.
For BlueZ use case this is correct. You need to use the controller with the required hardware capabilities(Firmware + hardware resources).
For the scenarios 1 and 2 the profiles and supporting protocols will be implemented in the controller.