bridging mqtt brokers hivemq and mosquitto

Question

I'm trying to bridge two MQTT brokers on the same system, HiveMQ and Mosquitto. HiveMQ is working on port 1884 and Mosquitto is running on 1883. However when I use the mosquitto_pub command to publish to the mosquitto broker at port 1883, it does not show up on port 1884 (Using MQTT.fx as a client subscribing to all topics on port 1884)

This is while I only configured the mosquitto broker with a bridge. When I configured HiveMQ as well, it only shows an unable to connect to Bridge1, disconnected message on the HiveMQ command window. I've included the configurations below. Someone please help.

In the mosquitto.config file I have done the following under bridges.

    connection hivemq
    address 127.0.0.1:1884 
    start_type automatic
    clientid clientno1
    notifications true

Meanwhile, I also editted the HiveMQ bridges.xml file to read

<?xml version="1.0" encoding="UTF-8"?>
<bridges xsi:noNamespaceSchemaLocation="http://www.hivemq.com/bridges/bridge.xsd" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance">

<bridge>
    <connectionName>Bridge1</connectionName>
    <addresses>
        <address>
            <host>localhost</host>
            <port>1883</port>
        </address>
    </addresses>
    <clientId>bridgeClient</clientId>
    <topicPatterns>
        <topicPattern>
            <topic>#</topic>
            <qos>1</qos>
            <direction>both</direction>
            <localPrefix>local/</localPrefix>
            <remotePrefix>remote/</remotePrefix>
        </topicPattern>
    </topicPatterns>
    <cleanSession>true</cleanSession>
    <idleTimeout>10</idleTimeout>
    <notificationsEnabled>true</notificationsEnabled>
    <tryPrivate>true</tryPrivate>

</bridge>

The image shown is when I tried the same process on another system. Here, the brokers are bridged. Comparing this to what I was doing earlier, the only difference is that on my original system there is no statement saying opening ipv4 listen socket on 1883. Is this the problem?

Answer 1

Bridging should only be set on the publisher/client side (mosquitto in your case), leaving default settings on Hivemq (server) should be fine

Try make changes to your mosquitto.conf

connection bridge-mosquitto-to-hivemq
address 127.0.0.1:1884 
topic room1/# both 2 sensor/ myhouse/
bridge_protocol_version mqttv311
notifications true
cleansession true
try_private true

After restart your brokers, at mosquitto broker, try publish an example message below

mosquitto_pub -t sensor/room1/temperature -m '26.3'