I have compiled u-boot from u-boot-2013.01.y branch for versatilebp board (arm), and I need fatload command that is not present in this configuation. I'm running u-boot under qemu
DRAM: 128 MiB
WARNING: Caches not enabled
Using default environment
In: serial
Out: serial
Err: serial
Net: SMC91111-0
Warning: SMC91111-0 using MAC address from net device
VersatilePB # fat
Unknown command 'fat' - try 'help'
VersatilePB # help
? - alias for 'help'
base - print or set address offset
bdinfo - print Board Info structure
bootm - boot application image from memory
bootp - boot image via network using BOOTP/TFTP protocol
cmp - memory compare
cp - memory copy
crc32 - checksum calculation
dhcp - boot image via network using DHCP/TFTP protocol
env - environment handling commands
erase - erase FLASH memory
flinfo - print FLASH memory information
go - start application at address 'addr'
help - print command description/usage
iminfo - print header information for application image
loop - infinite loop on address range
md - memory display
mm - memory modify (auto-incrementing address)
mtest - simple RAM read/write test
mw - memory write (fill)
nm - memory modify (constant address)
ping - send ICMP ECHO_REQUEST to network host
printenv- print environment variables
protect - enable or disable FLASH write protection
reset - Perform RESET of the CPU
setenv - set environment variables
tftpboot- boot image via network using TFTP protocol
version - print monitor, compiler and linker version
VersatilePB #
I need fatload to load file containing image of fat filesystem containing kernel of freebsd. Can I somehow change compile config for that board to compile u-boot with fatload command? Or it's just not possible/not supported for that board?
Having done more or less exactly this for a Versatile AB, it's most certainly possible. The simplest way is to find where that board's command set is defined, and hack in the commands you want by defining the relevant CONFIG_CMD_* symbols. In this case, that place is include/configs/versatile.h.
Looking at my checkout of 2015.07, I seem to have added, among others (I think I was trying to convince the MMC to work at the time), these lines:
#define CONFIG_CMD_FAT
#define CONFIG_DOS_PARTITION 1