I understand that the computer loads the first sector of memory known as BIOS, which runs diagnostics on hardware and the proceeds to load the OS. I guess my question leans towards the hardware side. How does the computer know which memory to boot from (RAM, ROM, FLASH, etc). I understand the differences between memory and I understand computers boot from the hard drive, but Im attempting to make an 8 bit computer with a z80 microprocessor, which will need to boot from ROM or Flash memory. The only problem is that the processor reads only from whatever memory the address pins are connected to and there are no separate address pins for ram and rom. Its also impractical to run the system on rom or flash due to the much slower read/write time compared to ram. The z80 to the best of my knowledge doesnt have separate commands for reading from rom and ram, and it wouldnt matter even if it did because the ram will be blank upon powering up. How does a computer choose to read from rom only upon booting and then switch to ram once the OS has been loaded. Is it hardwired in using logic gates? And how does a computer choose to write to flash memory or a hard drive instead of ram once the OS has been loaded? Would flash memory be treated as a device? Or is this also hardwired into the motherboard using logic gates? Sorry for giving so much background, I just dont want you to waste your time explaining things Ive already grasped. Ive just researched this to a great extent and thought about it for hours on end and cant seem to figure it out, and everywhere Ive looked doesnt explain how the computer chooses which memory to read from, it just says that it does. Thanks
I'm not sure I'm answering what you are asking, but I'll give it a try.
Some computers (at least, IBM PC-compatible computers), after powering up, usually run this BIOS (Basic Input/Output System) program. For this to happen, to the best of my knowledge, the hardware must make the jump to this code, and this code must be accessible (that is, mapped) from the physical memory, since that's where the CPU will execute code from. So, a physical address space with some read-only areas where this code is hard-wired to would do the trick.
Once the BIOS code is running, it can select how to proceed next. It can copy a sector from a hard disk to memory, (or a bunch of data from a Flash drive) and then jump to it, or whatever. That's up to the BIOS writer.