How should I convert Wifi signal strength from a Quality in percentage, usually 0% to 100% into an RSSI value, usually a negative dBm number (i.e. -96db)?
Microsoft defines Wifi signal quality in their WLAN_ASSOCIATION_ATTRIBUTES structure as follows:
wlanSignalQuality:
A percentage value that represents the signal quality of the network. WLAN_SIGNAL_QUALITY is of type ULONG. This member contains a value between 0 and 100. A value of 0 implies an actual RSSI signal strength of -100 dbm. A value of 100 implies an actual RSSI signal strength of -50 dbm. You can calculate the RSSI signal strength value for wlanSignalQuality values between 1 and 99 using linear interpolation.
RSSI (or "Radio (Received) Signal Strength Indicator") are in units of 'dB' (decibel) or the similar 'dBm' (dB per milliwatt) (See dB vs. dBm) in which the smaller magnitude negative numbers have the highest signal strength, or quality.
Therefore, the conversion between quality (percentage) and dBm is as follows:
quality = 2 * (dBm + 100) where dBm: [-100 to -50]
dBm = (quality / 2) - 100 where quality: [0 to 100]
Pseudo Code (with example clamping):
// dBm to Quality:
if(dBm <= -100)
quality = 0;
else if(dBm >= -50)
quality = 100;
else
quality = 2 * (dBm + 100);
// Quality to dBm:
if(quality <= 0)
dBm = -100;
else if(quality >= 100)
dBm = -50;
else
dBm = (quality / 2) - 100;
Note:
Check the definition of Quality that you are using for your calculations carefully. Also check the range of dB (or dBm). The limits may vary.
Examples:
Medium quality: 50% -> -75dBm = (50 / 2) - 100 Low quality: -96dBm -> 8% = 2 * (-96 + 100)