I am writing a device driver for a PCIe card in Linux. I am trying to use interrupts in my driver.
Reading the "IRQ Line" section of the PCI configuration register (offset 0x3C) reports that the assigned IRQ line for the device is 11. lspci -b -vv also reports that my device's interrupt number is 11.
Heres where it gets weird... cat /sys/bus/pci/devices/<my_device>/irq reports that the interrupt number is 19. lspci -vv also reports that the interrupt number is 19.
Requesting 11 in my driver does not work. If I request 19 in the driver, I catch interrupts just fine.
What gives?
Thanks!!!
I believe that it has to do with the difference between "physical" and "virtual" IRQ lines. Because the processor has a limited number of physical IRQ lines it assigns virtual IRQ lines to allow the total number of PCI devices to exceed the number of physical lines.
In this instance, 19 is your virtual IRQ line (as recognized by the processor) while 11 is the physical line (as recognized by the PCI device).
By the way, you should probably really get the IRQ number from the struct pci_dev for that device since they're dynamically generated.