I'm developing a custom PowerShell snap-in, which references another project in the solution.
When I try to debug the snap-in (following [these instructions][1]), the assembly fails to load and my cmdlet fails with the message "Could not load file or Assembly..."
How do you instruct PowerShell on how to locate assemblies, or how do you specify where are located the assemblies needed by the snap-in?
I'd prefer to avoid registering the assemblies in the GAC, at least during development.
Not sure of the exact behaviour, but I would try and make use of fuslogvw to see exactly where the runtime is looking for the problematic assemblies. That would give you a clue as to how to get them to be copied into the correct place on build. This post by Scott Hanselman is quite useful, and this is the official documentation.
If you find the solution, please add an answer, as this must be a common scenario.