I'm using vim to edit some python files and recently it occurs sporadically that the syntax highlighting disappears after I save the buffer inside vim. I tried to reset syntax on and set filetype=python but to no avail. I have no clue of what causes this problem at all, so right now I have minimal diagnostic info. But has anyone encountered this before, or where could things break down?
This is not a solution, but it's hard to write/read in the comments.
I meant that I was messing around with syntax/highlighting when I start to fix my own .vimrc, thats why I noticed it.
syntax on / syntax enable is only preparing for file load stuff (adding a lot of au to BufNewFile / BufRead). So if some plugin is messing with syntax/highlight settings when writing the file, the file must be loaded again for all "magic" to happen, it's not enough with setting filetype. Do :au BufRead and you will see all autocommands added when starting syntax. But the file must be loaded then to get all settigs.
See this:> syntax-loading
If you don't want to reload the file, try syntax enable, I think that is different to syntax on.
Or try also doing :doautocmd filetypedetect BufRead %, see > autocmd-execute
I don't know what is causing the problem, can it be you? If you added some autocommands, or doing own colors/syntax?
Otherwise, until you get a solution, you can perhaps try to add autocmd BufWritePost * <with the commands above that works> at the end of your .vimrc, use augroup in that case.
Here is an example:
augroup myResetSyntax
au!
autocmd BufWritePost * syntax enable | doautocmd filetypedetect BufRead "%"
augroup END